Shaped and glassed!

After gluing up the deck, the next part is to clean up the planks and shape the blank.
So with much planer work I have this:


I also decided to put a tail block on:


And blended it in:


After it was all blended in and smoothed/shaped out, it was time to lay down some glass. The schedule for this board is 1 x 4oz S glass bottom with cutlaps and 2 x 4oz S glass deck with cutlaps.

So here it is glassed:


Finally, today I installed the fin boxes. They are probox boxes in a quad setup:


Next step is to put the leash plug in and sand. Then I have a vent plug that I am going to install. The board is nearly done! :)